The Archive Full (%) metric returns the percentage of space used on the archive area destination. If the space used is more than the threshold value given in the threshold arguments, then a warning or critical alert is generated.
The rest of the information in this section is only valid for this metric when it appears in either the Enterprise Manager Grid Control or the Enterprise Manager Database Control (if applicable).
The following table shows how often the metric's value is collected and compared against the default thresholds. The 'Consecutive Number of Occurrences Preceding Notification' column indicates the consecutive number of times the comparison against thresholds should hold TRUE before an alert is generated.
|
Target Version |
Evaluation and Collection Frequency |
Upload Frequency |
Operator |
Default Warning Threshold |
Default Critical Threshold |
Consecutive Number of Occurrences Preceding Notification |
Alert Text |
|
All Versions |
Every 15 Minutes |
After Every Sample |
> |
80 |
Not Defined |
1 |
%value%%% of archive area %archDir% is used. |
For this metric you can set different warning and critical threshold values for each "Archive Area Destination" object.
If warning or critical threshold values are currently set for any "Archive Area Destination" object, those thresholds can be viewed on the Metric Detail page for this metric.
To specify or change warning or critical threshold values for each "Archive Area Destination" object, use the Edit Thresholds page. See Editing Thresholds for information on accessing the Edit Thresholds page.
If no quota is set for archive area, the percentage is calculated using the UNIX df –k command.
If quota is set:
archive area used (%) = (total area used / total archive area) * 100
Verify the device specified in the initialization parameter LOG_ARCHIVE_DEST is set up properly for archiving.
There are two methods you can use to specify archive destinations. These destinations can be setup using Enterprise Manager. For each database target, you can drill-down to the database Availability tab, and access the Recovery Settings page.
The first method is to use the LOG_ARCHIVE_DEST_n parameter (where n is an integer from 1 to 10) to specify from one to ten different destinations for archival. Each numerically-suffixed parameter uniquely identifies an individual destination, for example, LOG_ARCHIVE_DEST_1, LOG_ARCHIVE_DEST_2, and so on.
The second method, which allows you to specify a maximum of two locations, is to use the LOG_ARCHIVE_DEST parameter to specify a primary archive destination and the LOG_ARCHIVE_DUPLEX_DEST parameter to determine an optional secondary location.
If the LOG_ARCHIVE_DEST initialization parameter is set up correctly and this metric triggers, then free up more space in the destination specified by the archive destination parameters.
Related Topics
About Alerts
About the Metric Detail Page
Editing Thresholds
Understanding Line Charts
Copyright © 1996, 2009, Oracle and/or its affiliates. All rights reserved.
Oracle is a registered trademark of Oracle Corporation and/or its affiliates.
Other names may be trademarks of their respective owners.