Skip Headers
Oracle® Collaboration Suite Installation Guide
10g Release 1 (10.1.2) for Microsoft Windows

Part Number B25463-03
Go to Documentation Home
Go to Book List
Book List
Go to Table of Contents
Go to Index
Go to Master Index
Master Index
Go to Feedback page
Contact Us

Go to previous page
Go to next page
View PDF

G Using Command-Line Options and Variables

This appendix explains the command-line options and variables that can be used to run the Oracle Universal Installer for installing Oracle Collaboration Suite. It contains the following topics:

This section contains the following topics:

G.1 Running Prerequisite Checks

You can just run the prerequisite checks without having to install Oracle Collaboration Suite components by using the following command:

Drive_Letter:\> setup.exe -prereqChecker PREREQ_CONFIG_LOCATION=path_to_/stage/prereq 
-entryPoint entry_point

In the preceding syntax, the value of entry_point can be any of the following:

G.2 Starting Oracle Universal Installer

You can start the Oracle Universal Installer by using the following command:

Drive_Letter:\> setup.exe [options] [CommandLineVariable=Value]

In the preceding syntax, [options] can have the following values:

G.3 Specifying Custom Ports

For Oracle Collaboration Suite installation, you can specify custom port numbers in the following two ways:

The Ports Configuration Screen enables you to select custom port numbers only for a few well-known ports. On the other hand, the staticports.ini file provides a wider range of the ports that can be used during installation.


If you pass the path to the staticports.ini file as a parameter while running the setup.exe command, then the Ports Configuration Options screen will not appear during the installation.

A sample staticports.ini file is located in the \response directory of the Oracle Collaboration Suite DVD.

The command-line options used to specify staticports.ini file are as follows: