Siebel Server Installation Guide for Microsoft Windows > Installing the Siebel Server > Installation Tasks for the Siebel Server >

Pre-Installation Checklist for the Siebel Server

Make sure you perform the following tasks before installing the Siebel Server.

  1. Make sure that you have installed the Siebel Gateway and that it is running. To check the status of this service, navigate to the Services dialog box, through the Windows Control Panel.
  2. NOTE:  You will be unable to complete the Siebel Server installation if the Siebel Gateway is not running.

  3. Shut down all open programs running on the server.
  4. Stop any active Siebel Server Windows 2000 or Siebel Server Windows NT services, except the Siebel Gateway.
  5. CAUTION:  To install Siebel eBusiness Applications, you must have 50-100 MB of disk space on your system drive (usually C:) even if you intend to install Siebel eBusiness Applications into another drive.

  1. Make sure that you have already installed the appropriate version of all third-party software products required before you install the Siebel Server. Otherwise, the Required Software Components prompt appears. For more information, see System Requirements and Supported Platforms.
  2. NOTE:  Siebel Server requires MDAC and MFC installed.

 Siebel Server Installation Guide for Microsoft Windows 
 Published: 25 June 2003