7.4 NDB Transporter Errors

This section lists error codes, names, and messages that are written to the cluster log in the event of transporter errors.

Error CodeError NameError Text
0x00TE_NO_ERRORNo error
0x01TE_ERROR_CLOSING_SOCKETError found during closing of socket
0x02TE_ERROR_IN_SELECT_BEFORE_ACCEPTError found before accept. The transporter will retry
0x03TE_INVALID_MESSAGE_LENGTHError found in message (invalid message length)
0x04TE_INVALID_CHECKSUMError found in message (checksum)
0x05TE_COULD_NOT_CREATE_SOCKETError found while creating socket(can't create socket)
0x06TE_COULD_NOT_BIND_SOCKETError found while binding server socket
0x07TE_LISTEN_FAILEDError found while listening to server socket
0x08TE_ACCEPT_RETURN_ERRORError found during accept(accept return error)
0x0bTE_SHM_DISCONNECTThe remote node has disconnected
0x0cTE_SHM_IPC_STATUnable to check shm segment
0x0dTE_SHM_UNABLE_TO_CREATE_SEGMENTUnable to create shm segment
0x0eTE_SHM_UNABLE_TO_ATTACH_SEGMENTUnable to attach shm segment
0x0fTE_SHM_UNABLE_TO_REMOVE_SEGMENTUnable to remove shm segment
0x10TE_TOO_SMALL_SIGIDSig ID too small
0x11TE_TOO_LARGE_SIGIDSig ID too large
0x12TE_WAIT_STACK_FULLWait stack was full
0x13TE_RECEIVE_BUFFER_FULLReceive buffer was full
0x14TE_SIGNAL_LOST_SEND_BUFFER_FULLSend buffer was full,and trying to force send fails
0x15TE_SIGNAL_LOSTSend failed for unknown reason(signal lost)
0x16TE_SEND_BUFFER_FULLThe send buffer was full, but sleeping for a while solved
0x0017TE_SCI_LINK_ERRORThere is no link from this node to the switch
0x18TE_SCI_UNABLE_TO_START_SEQUENCECould not start a sequence, because system resources are exumed or no sequence has been created
0x19TE_SCI_UNABLE_TO_REMOVE_SEQUENCECould not remove a sequence
0x1aTE_SCI_UNABLE_TO_CREATE_SEQUENCECould not create a sequence, because system resources are exempted. Must reboot
0x1bTE_SCI_UNRECOVERABLE_DATA_TFX_ERRORTried to send data on redundant link but failed
0x1cTE_SCI_CANNOT_INIT_LOCALSEGMENTCannot initialize local segment
0x1dTE_SCI_CANNOT_MAP_REMOTESEGMENTCannot map remote segment
0x1eTE_SCI_UNABLE_TO_UNMAP_SEGMENTCannot free the resources used by this segment (step 1)
0x1fTE_SCI_UNABLE_TO_REMOVE_SEGMENTCannot free the resources used by this segment (step 2)
0x20TE_SCI_UNABLE_TO_DISCONNECT_SEGMENTCannot disconnect from a remote segment
0x21TE_SHM_IPC_PERMANENTShm ipc Permanent error
0x22TE_SCI_UNABLE_TO_CLOSE_CHANNELUnable to close the sci channel and the resources allocated