|Skip Navigation Links|
|Exit Print View|
|Oracle Solaris Cluster Data Service for Solaris Containers Guide Oracle Solaris Cluster|
The procedure that follows is required only if you are applying a patch to the global zone and to non-global zones. If you are applying a patch to only the global zone, follow the instructions in Chapter 11, Patching Oracle Solaris Cluster Software and Firmware, in Oracle Solaris Cluster System Administration Guide.
This task applies to both nonrebooting patches and rebooting patches.
Perform this task on all nodes in the cluster.
Some zones might be configured to run in a failover configuration. In this situation, bring online on the node that you are patching the resource group that contains the resources for the zones' disk storage.
# clresourcegroup switch -n node solaris-zone-resource-group
Note - This step might also start any applications managed within the resource group solaris-zone-resource-group. Verify if you need to stop any application prior to install the patches. If the applications need to be stopped, disable the corresponding resources before proceeding to the next step.
Note - If the patches need to get applied in single-user mode, it will not be possible to start the resource group as described. Instead the corresponding zone paths need to get mounted manually.
For detailed instructions, see Chapter 11, Patching Oracle Solaris Cluster Software and Firmware, in Oracle Solaris Cluster System Administration Guide in Oracle Solaris Cluster System Administration Guide.