After installation is complete, you must run the System Reliability Manager setup wizard to configure the server and agent layers. You can perform the setup procedure directly after the software installation is complete. You can also exit the installation wizard and perform the setup procedure later. The Sun Management Center 3.6 core server layer must be set up before starting the System Reliability Manager setup procedure.
The Sun Management Center 3.6 installation wizard can launch the System Reliability Manager setup wizard. The setup wizard appears after the Installation Complete panel when using the installation wizard. The System Reliability Manager setup wizard guides you through the setup procedure. For the command-line instructions for running the setup script, see Appendix A, Installing System Reliability Manager Using the Command Line.
For more information and detailed steps, see Sun Management Center 3.6 Installation and Configuration Guide.
Perform this procedure only after the Sun Management Center 3.6 software has been already installed. This procedure assumes that you chose not to set up System Reliability Manager 3.6 at the end of the installation process.
As superuser (su -), launch the Sun Management Center 3.6 setup wizard by typing:
where /opt is the directory in which Sun Management Center 3.6 is installed. Substitute the name of the actual directory if it is different on your system.
The Sun Management Center 3.6 setup wizard appears and guides you through the setup process for the software.
If you have installed more than one add-on product, the setup wizard for each product appears automatically. Each wizard guides you through the setup process for its add-on product. Each new setup wizard appears automatically after the setup process is completed for the previous add-on product. The setup wizard for the System Reliability Manager software might not be the first to appear in this case.
The Overview panel appears first. Click Next to continue through the wizard panels.
Review the list in the Stopping Components panel and click Next.
The Sun Management Center components must be stopped before the setup process can continue.
The Advanced Setup Options panel appears if you have completed the setup process for some of the add-on products installed. The remaining add-on software can be setup now. Select from the following options and click Next:
Reconfigure All – The setup process is run again for the base Sun Management Center 3.6 software and all add-on software. All the Sun Management Center software that was previously set up is set up again.
Configure Addons – The add-on software that was recently installed but not yet set up is now set up.
Review the list of products in the Sun Management Center Base Product Setup Complete panel and click Next.
The Select Add-on Products panel appears. All products newly installed on the system that will be set up are listed. You are also given the option to run setup again on any product that has already been set up.
Confirm that System Reliability Manager appears as a product to be set up now and click Next.
The setup progress bar appears. Once the progress bar is done, the Add-on Products Setup panel appears.
Once the setup procedure is complete, you have the option to start the Sun Management Center processes. For more information, see Sun Management Center 3.6Installation and Configuration Guide.