Replacing the Centerplane
-
Place the centerplane in the front chassis.
Be sure the centerplane has the proper orientation when placed in the front chassis.
-
Replace the screws that hold the centerplane to the front chassis.
-
For the Enterprise 6500 system, there are a total of 27 screws, 20 screws around the side and 7 in the interior section.
-
For the Enterprise 5500 system, there are a total of 20 screws.
-
-
Place the rear chassis on the front chassis.
-
Replace the screws around the center of the main chassis.
-
For the Enterprise 6500 system, there are a total of 32 screws, 8 per side.
-
For the Enterprise 5500 system, there are a total of 26 screws.
Caution - Use care when lifting the Enterprise system chassis. It weighs approximately 100 pounds.
-
-
Slide the main chassis into the system cabinet.
Use the bottom rails as a guide.
-
Replace the four screws on each side of the system cabinet that attach the bottom rails to the main chassis.
-
Replace the top rails.
-
Replace the SCSI adapter assembly, the key switch adapter assembly, and the 200/240V fan tray assembly.
See "SCSI Tape Adapter PCS Assembly", "Key Switch Adapter Assembly", and "Fan Tray Assembly, 200/240V" for information on replacing these assemblies.
-
Replace all the boards and power supplies.
See Chapters 3-6 for information on replacing the boards and Chapter 7, Power Supplies, for information on replacing power supplies.
-
Connect any remaining cables to the Enterprise system main cabinet.
-
Replace any assemblies above and below the Enterprise system.
Refer to the respective service manuals for further information.
-
Replace the front bezel, front door and rear screen panel.
See Chapter 12, Preparing for Service, for information on replacing these assemblies.
-
Power on the Enterprise system.
See the power on instructions in Chapter 11, Powering Off and On .
- © 2010, Oracle Corporation and/or its affiliates