You must remove the fan tray screen (Figure E-1) to reach the assembly.
There is also a fan tray in the card cage ("Fan Tray Assembly, 200/240V") and one fan in the media tray.
Loosen the four screws on the left and the four screws on the right of the fan tray screen.
It is not necessary to completely remove these four screws.
Lift the screen up until the slotted screw holes clear the screw heads, and set it aside.
Disconnect the power cable and fan cable assembly.
Loosen the two captive screws on the fan tray assembly (Figure E-1).
Tilt the fan tray assembly back slightly so that it clears the top of the cabinet.
Remove the fan tray assembly.
Tilt the fan tray assembly inward and lower it behind the upper sequencer bracket.
Push the fan tray into the cabinet until the fan tray cannot be inserted any further.
Tighten the two captive screws at the top and bottom of the fan tray (Figure E-1).
Replace the power cable and fan fail cable.