test

Sun Enterprise 6500/5500/4500 Systems Reference Manual

SCSI Tape Adapter PCS Assembly

Removing the SCSI Adapter Assembly

  1. Completely power off the Enterprise system.

    See the power off instructions in Chapter 11, Powering Off and On .

  2. Disconnect the two cable assemblies from the front of the SCSI adapter assembly (Figure E-6).

  3. Loosen the three captive screws on the bottom that secure the SCSI adapter assembly to the cabinet (Figure E-12).

    Figure E-12 Removing the SCSI Tape Adapter PCS Assembly in the Enterprise 6500/5500 Systems

    Graphic

  4. Pull and slowly remove the SCSI adapter assembly from the cabinet.

Replacing the SCSI Adapter Assembly

  1. Carefully insert the SCSI adapter assembly into the front of the Enterprise system.

    Caution - Caution -

    DO NOT FORCE the SCSI adapter assembly into the slot; this can cause damage to the assembly and system.

    The SCSI adapter assembly should insert and seat smoothly. If it binds, remove it, and inspect the slot for any obvious obstructions. Do not damage the springfingers at the bottom of the assembly.

  2. Tighten the three captive screws on the bottom that secure the SCSI adapter assembly to the cabinet (Figure E-12).

  3. Connect the two cable assemblies to the front of the SCSI adapter assembly (Figure E-6).

  4. Power on the Enterprise system.

    See the power on instructions in Chapter 11, Powering Off and On .