This procedure describes how to initiate, as well as disable, the network device-discovery/printers service (the HAL add-on module) by using the SMF.
Become superuser or assume an equivalent role.
Determine whether the SMF device-discovery/printers service is online.
# svcs device-discovery/printers |
If the service is online, the following output is displayed:
STATE STIME FMRI online 13:30:22 svc:/network/device-discovery/printers:snmp |
If the service is offline, the following output is displayed:
STATE STIME FMRI disabled Dec_12 svc:/network/device-discovery/printers:snmp |
To enable or disable the service instance, use the appropriate command.
Verify that the HAL add-on module has been enabled or disabled.
If the module has been successfully enabled, the output is as follows:
# svcs device-discovery/printers STATE STIME FMRI online 13:30:22 svc:/network/device-discovery/printers:snmp |
If the module has been successfully disabled, the output is as follows:
# svcs device-discovery/printers STATE STIME FMRI disabled Dec_12 svc:/network/device-discovery/printers:snmp |