To Configure the Message Protection Policies for a Provider

Typically, you would not reconfigure a provider. However, if needed for your situation, you can modify a provider's message protection policies by changing provider type, implementation class, and provider-specific configuration properties. To understand the results of different combinations, see Table 13–1.

Use the set(1) subcommand to set the response policy, then replace the word request in the following commands with the word response.

1. Add a request policy to the client and set the authentication source by using the set(1) subcommand.

   For example:

   asadmin> set server-config.security-service.message-security-config.SOAP. provider-config.ClientProvider.request-policy.auth_source=[sender | content]

2. Add a request policy to the server and set the authentication source by using the set subcommand.

   For example:

   asadmin> set server-config.security-service.message-security-config.SOAP. provider-config.ServerProvider.request-policy.auth_source=[sender | content]

3. Add a request policy to the client and set the authentication recipient by using the set subcommand:

   For example:

   asadmin> set server-config.security-service.message-security-config.SOAP. provider-config.ClientProvider.request-policy.auth_recipient=[before-content | after-content]

4. Add a request policy to the server and set the authentication recipient by using the set subcommand:

   For example:

   asadmin> set server-config.security-service.message-security-config.SOAP. provider-config.ServerProvider.request-policy.auth_recipient=[before-content | after-content]