Solaris Volume Manager Administration Guide

ProcedureHow to Create a RAID-0 (Stripe) Volume

Before You Begin

Check Prerequisites for Creating Solaris Volume Manager Components and Background Information for Creating RAID-0 Volumes.

Step

    To create a stripe volume, use one of the following methods:

    • From the Enhanced Storage tool within the Solaris Management Console, open the Volumes node. Choose Action⇒Create Volume, then follow the instructions in the wizard. For more information, see the online help.

    • Use the following form of the metainit command:


      # metainit volume-name number-of-stripes
       components-per-stripe 
      component-names
      [ -i interlace]
      
      volume-name

      Specifies the name of the volume to create. For information on naming volumes, see Volume Names.

      number-of-stripes

      Specifies the number of stripes to create.

      components-per-stripe

      Specifies the number of components each stripe should have.

      component-names

      Specifies the names of the components that are used. If more than one component is used, separate each component with a space.

      -i interlace

      Specifies the interlace width to use for the stripe. The interlace width is a value, followed by either `k' for kilobytes, `m' for megabytes, or `b' for blocks. The interlace specified cannot be less than 16 blocks, or greater than 100 megabytes. The default interlace width is 16 kilobytes.

      See the following examples and the metainit(1M) man page for more information.


Example 9–1 Creating a RAID–0 (Stripe) Volume of Three Slices


# metainit d20 1 3 c0t1d0s2 c0t2d0s2 c0t3d0s2
d20: Concat/Stripe is setup

This example shows the stripe, d20, consists of a single stripe (the number 1). The stripe is composed of three slices (the number 3). Because no interlace value is specified, the stripe uses the default of 16 Kbytes. The system confirms that the volume has been set up.



Example 9–2 Creating a RAID-0 (Stripe) Volume of Two Slices With a 32–Kbyte Interlace Value


# metainit d10 1 2 c0t1d0s2 c0t2d0s2 -i 32k
d10: Concat/Stripe is setup

This example shows the stripe, d10, consists of a single stripe (the number 1). The stripe is composed of two slices (the number 2). The -i option sets the interlace value to 32 Kbytes. (The interlace value cannot be less than 8 Kbytes, nor greater than 100 Mbytes.) The system verifies that the volume has been set up.


See Also

To prepare the newly created stripe for a file system, see Chapter 18, Creating UFS, TMPFS, and LOFS File Systems (Tasks), in System Administration Guide: Devices and File Systems. Some applications, such as a database, do not use a file system. These applications instead use the raw device. The application must have its own way of accessing the raw device.