To Load the Smartcard Applet to a Smart Card (Command Line)

Steps

1. Verify that the ocfserv daemon is enabled.

   The following command provides the status of the service.

   % svcs network/rpc/ocfserv

   ---

   Note –

   Before you make any changes to Smartcard, you must make sure that the ocfserv daemon is enabled.

   ---

2. (Optional) If necessary, as root, enable the ocfserv daemon.

   # svcadm enable network/rpc/ocfserv

3. With the smart card inserted in the card reader, type the following:

   # smartcard -c load -i /usr/share/lib/smartcard/SolarisAuthApplet.capx

   When the load finishes, the following message is displayed:

   Operation successful.