The following high-level tasks are required:
Checking the installation sequence guidelines.
Check to see what guidelines apply to this example and make adjustments as needed.
Checking the installation prerequisites.
Check to see what tasks you might need to perform for this installation before starting.
Running the installer.
At component selection, choosing Access Manager SDK.
The installer verifies software on your host and provides guidance if incompatibilities are identified.
Selecting the Configure Later type.
Running the installation.
Viewing the Installation Summary and Log.
Verifying that your web container is installed and running.
Editing the amsamplesilent file.
Make a copy the amsamplesilent file.
By default, many settings are commented out in the amsamplesilent file. Uncomment only the following settings:
Modify only the following parameters in the amsamplesilent file:
DEPLOY_LEVEL should be set to 4.
SERVER_HOST and SERVER_PORT should be set to the host and port of the full server which will be used by Access Manager SDK.
DS_HOST, DS_DIRMGRPASSWD, and ROOT_SUFFIX should be set to the hostname, directory manager password, and root suffix of the Host A Directory Server.
ADMINPASSWD and AMLDAPUSERPASSWD should be set to the amadmin and amldapuser passwords used on Host A.
AM_ENC_PWD should be set to the password encryption key used on Host A. For the Access Manager SDK, use the same encryption key for AM_ENC_PWD as the encryption key specified during the remote installation of Access Manager on Host B. Use one of the following commands to obtain this value:
Solaris: grep pwd /etc/opt/SUNWam/config/AMConfig.properties
Linux: grep pwd /etc/opt/sun/identity/config/AMConfig.properties
WEB_CONTAINER should be set to the corresponding value for the web container being used.
BASEDIR should be set to the install directory used during the Configure Later installation of Access Manager SDK.
AM_REALM should be set to Enabled if realm mode is used on Host A, and Disabled if legacy mode is used on Host A.
Find the settings corresponding to the web container that will be used for the SDK and modify these settings with the details of the web container. For example, if WEB_CONTAINER is set to WS (Sun Java System Web Server), then you should modify the settings which are prefixed by WS_ (WS_INSTANCE , WS_HOME, WS_PROTOCOL and so on.)
As root, use the edited amsamplesilent file to deploy Access Manager.
Restarting your web container