Sun Cluster Geographic Edition Data Replication Guide for EMC Symmetrix Remote Data Facility

ProcedureHow to Modify an EMC Symmetrix Remote Data Facility Protection Group

Before You Begin

Before modifying the configuration of your protection group, ensure that the protection group you want to modify exists locally.

  1. Log in to one of the cluster nodes.

    You must be assigned the Geo Management RBAC rights profile to complete this procedure. For more information about RBAC, see Sun Cluster Geographic Edition Software and RBAC in Sun Cluster Geographic Edition System Administration Guide.

  2. Modify the configuration of the protection group.

    This command modifies the properties of a protection group on all nodes of the local cluster. If the partner cluster contains a protection group of the same name, this command also propagates the new configuration information to the partner cluster.


    # geopg set-prop -p property [-p...] protectiongroupname
    
    -p propertysetting

    Specifies the properties of the protection group.

    For more information about the properties you can set, see Appendix A, Standard Sun Cluster Geographic Edition Properties, in Sun Cluster Geographic Edition System Administration Guide.

    protectiongroupname

    Specifies the name of the protection group.

    For information about the names and values that are supported by Sun Cluster Geographic Edition software, see Appendix B, Legal Names and Values of Sun Cluster Geographic Edition Entities, in Sun Cluster Geographic Edition System Administration Guide.

    For more information about the geopg command, refer to the geopg(1M) man page.


Example 2–4 Modifying the Configuration of a Protection Group

This example modifies the Timeout property of the protection group that was created in Example 2–2.


# geopg set-prop -p Timeout=2700 srdfpg