You can remove an application resource group from a protection group without altering the state or contents of an application resource group.
Ensure that the following conditions are met:
The protection group is defined on the local cluster.
The resource group to be removed is part of the application resource groups of the protection group.
Log in to a cluster node.
You must be assigned the Geo Management RBAC rights profile to complete this procedure. For more information about RBAC, see Sun Cluster Geographic Edition Software and RBAC in Sun Cluster Geographic Edition System Administration Guide.
Remove the application resource group from the protection group.
This command removes an application resource group from the protection group on the local cluster. If the partner cluster contains a protection group of the same name, then the command removes the application resource group from the protection group on the partner cluster.
If resource groups in the protection group have dependencies between them, you must remove all affected resource groups in the same geopg remove-resource-groupcommand.
# geopg remove-resource-group resourcegrouplist protectiongroup
Specifies the list of application resource groups.
You can specify more than one resource group in a comma-separated list.
Specifies the name of the protection group.
If the remove operation is unsuccessful on the local cluster, the configuration of the protection group is not modified. Otherwise, the Configuration status is set to OK on the local cluster.
If the Configuration status is OK on the local cluster, but the remove operation is unsuccessful on the partner cluster, the Configuration status is set to Error on the partner cluster.
This example removes two application resource groups, apprg1 and apprg2, from srdfpg.
# geopg remove-resource-group apprg1,apprg2 srdfpg