Sun Cluster Geographic Edition Data Replication Guide for Hitachi TrueCopy

ProcedureHow to Delete an Application Resource Group From a Hitachi TrueCopy Protection Group

You can remove an application resource group from a protection group without altering the state or contents of an application resource group.

Before You Begin

Ensure that the following conditions are met:

  1. Log in to a cluster node.

    You must be assigned the Geo Management RBAC rights profile to complete this procedure. For more information about RBAC, see Sun Cluster Geographic Edition Software and RBAC in Sun Cluster Geographic Edition System Administration Guide.

  2. Remove the application resource group from the protection group.

    This command removes an application resource group from the protection group on the local cluster. If the partner cluster contains a protection group of the same name, then the command removes the application resource group from the protection group on the partner cluster.


    # geopg remove-resource-group resourcegrouplist protectiongroup
    
    resourcegrouplist

    Specifies the name of the application resource group. You can specify more than one resource group in a comma-separated list.

    protectiongroup

    Specifies the name of the protection group.

    If the remove operation is unsuccessful on the local cluster, the configuration of the protection group is not modified. Otherwise, the Configuration status is set to OK on the local cluster.

    If the Configuration status is OK on the local cluster, but the remove operation is unsuccessful on the partner cluster, the Configuration status is set to Error on the partner cluster.


Example 2–10 Deleting an Application Resource Group From a Protection Group

This example removes two application resource groups, apprg1 and apprg2, from tcpg.


# geopg remove-resource-group apprg1,apprg2 tcpg