About This Documentation (PDF and HTML)
Related Third-Party Web Site References
Sun SSM Component Manager Overview
Upgrading from Previous Versions
(Linux and Solaris) Using Component Manager
(Linux and Solaris) Using Component Manager in Interactive Mode
(Linux and Solaris) Using Component Manager in Unattended Mode
(Windows) Using Component Manager
(Windows) Using the Component Manager Graphic Interface
(Windows) Using Component Manager Command-line Interface
CLI Tools Command Syntax and Conventions
CLI Tools Device-Naming Convention
Configuring the Device Boot Order
Configuring Individual CMOS Settings
Commands That Produce Unrelated, Innocuous, Extra Output
fwupdate Command-Line Interface
How To Show a Detailed Listing
How To Show a Brief Listing of a Disk
remove spare Subcommand and Options
How to Remove a Spare Disk or a RAID Volume
How to Modify a RAID Volume Name
How to Export an Inventory to a File
How to Configure RAID Volumes from a File
Sun IPMI System Management Driver 2.1
How to Install Sun IPMI System Management Driver 2.1 Manually
How to Perform an Unattended Installation of the Sun IPMI System Management Driver 2.1
How to Verify ipmitool Installation
How to Configure for PXE to Boot First
How to Configure for the Hard Drive to Boot First
How to Configure for Any CD/DVD to Boot First
How to Configure for Any Floppy or Removable Media to Boot First
After firmware for a device has been updated, the device might need to be reset. This requirement is different with each device; therefore, the reset functionality might be part of the update procedure or a separate function. To determine if your device requires a reset after a firmware upgrade, consult the release notes of your firmware.
The supported device_types for the fwupdate reset command are:
all
disk
expander
bridge
controller
Options for the update subcommand are shown in the following table.
|
The following is a fwupdate reset subcommand example. This example resets the disk mapped to c2d2.
# fwupdate reset disk -n c2d2
See also: