| Skip Navigation Links | |
| Exit Print View | |
|
Sun Blade Storage Module M2 Product Documentation |
About This Documentation (PDF and HTML)
Overview of the Sun Blade Storage Module M2
Installing the Storage Module Into the Chassis
Assigning and Managing Storage
Overview of the Sun Blade Storage Module M2 Product Notes
Supported Firmware, Hardware and Software
Solaris Operating System Issues
Solaris Operating System Current Issues
Disk Fault and Ready-to-Remove LEDs Do Not Work in Oracle Solaris 10 (6926642)
stmsboot Fails to Map Root Device After a Fresh OS Install (6931924)
Using stmsboot -d to Disable MPxIO Can Cause the System to Not Reboot Successfully (6923599)
Changes in Drive Physical Configuration Causes the Solaris format Utility to Hang (6890270, 6930996)
Removal of Devices Breaks mpathadm in Solaris (6908971, 6919439)
cfgadm -c unconfigure Fails if Path Specified is to an MPXIO Enabled Device (6948701)
Storage Module Disk Ready-to-Remove LED Does Not Work Using cfgadm (6946124)
Performing Maintenance and Hot Plug Actions
Importing Existing Virtual Drives to a Replacement REM
Storage Module Sensors and Indicators
Introduction to the Sun Blade Storage Module M2
Maintaining the Sun Blade Storage Module M2
The supported RAID types for the Sun Storage 6Gb SAS REM HBA (SGX-SAS6-REM-Z) are 0, 1, and 10. However, there is also no FCode command (in the SPARC OBP environment), or SAS2IRCU command to specifically create a RAID 10 volume.
If you want to create a RAID 10 volume, the SAS2IRCU includes a command that allows you create a RAID 1E volume (create-raid1e-volume). When you use the create-raid1e-volume command to create a volume, the SAS2IRCU utility actually creates a RAID 10 volume.
|