In the Solaris 8 release, you can use the per-route metrics to associate some properties with IPv4 and IPv6 routing table entries.
For example, a system has two different network interfaces, fast ethernet interface and gigabit ethernet interface. The system default tcp_recv_hiwat is 24,576 bytes. This default is sufficient for the fast ethernet interface, but may not be sufficient for the gigabit ethernet interface.
Instead of increasing the system's default tcp_recv_hiwat, you can associate a different default TCP receive window size to the gigabit ethernet interface routing entry. By making this association, all TCP connections going through the route will have the increased receive window size.
Assuming IPv4, the following is in the routing table (netstat -rn).
184.108.40.206 220.127.116.11 U 1 4 hme0 18.104.22.168 22.214.171.124 U 1 4 ge0 default 126.96.36.199 UG 1 8
Do the following:
# route change -net 188.8.131.52 -recvpipe x
This means all connections going to the 184.108.40.206 network, which is on the ge0 link, use the receive buffer size x, instead of the default 24567 receive window size.
If the destination is in the a.b.c.d network, and there is no specific routing entry for that network, you can add a prefix route to that network and change the metric. For example:
# route add -net a.b.c.d 220.127.116.11 -netmask w.x.y.z # route change -net a.b.c.d -recvpipe y
Note that the prefix route's gateway is the default router. Then all connections going to that network use receive buffer size y. If you have more than one interface, use the -ifp argument to specify which interface to use. This way, you can control which interface to use for specific destinations. Use the route(1M) get command to verify the metric.