uata(7D)

NAME | SYNOPSIS | DESCRIPTION | FILES | SEE ALSO | DIAGNOSTICS

NAME

uata– IDE Host Bus Adapter Driver

SYNOPSIS

ide@unit-address 

DESCRIPTION

The uata host bus adapter driver is a nexus driver that supports the ide interface on SPARC platforms. The driver supports ultra DMA mode-4 (ATA66). The driver also attempts to set the disk and ATAPI CD-ROM drive to maximum supported speed for the device.

Currently, the uata driver supports IDE controllers CMD646U and Acer Southbridge M5229.

The uata driver supports two channels concurrently with two devices connected per channel. The devices are logically numbered from 0 to 3:

0

Master disk on primary channel

1

Slave disk on primary channel

2

Master disk on secondary channel

3

Slave disk on secondary channel

FILES

/kernel/drv/uata

SEE ALSO

prtconf(1M), driver.conf(4) , attributes(5)

Writing Device Drivers

OpenBoot 3.x Command Reference Manual

X3T10 ATA-4 specifications

DIAGNOSTICS

In addition to being logged, the following messages may appear on the system console:

ddi_get_iblock_cookie failed

The driver could not obtain the interrupt cookie; the attach may fail.

Drive not ready before set_features

Indicates a fatal problem; the drives are not ready to be programmed and features cannot be set. (During the driver initialization process, the driver must set the features for the drive, including dma and pio.)

Interrupt not seen after set_features

Indicates a fatal problem with the drive; features could not be set.

ata_controller - set features failed

Indicates a fatal problem with the drive; features could not be set.

? target %d lun 0

Displayed at boot up time to indicate that target <#number> was identified.

resid = %x

A residual in data transfer and the I/O operation could not be finished completely.

ghd_timer_newstate: HBA reset failed

Generally indicates a fatal condition; I/O operation could not be completed following reset of the channel.

timeout: <msgp> target = %d lun=0

msgp could be early abort, early timeout, abort request, abort device, reset target, reset bus.

ata_controller - Drive not ready before command %x

The drive did not respond before issuing the command %x to the controller; ccommand %x will not be issued to the drive. (%x is the opcode for the sleep or standby commands, which are issued when the drive transitions between power management states.)

ata_controller - Command %x failed

The command %x failed on the drive. (%x is the opcode for the sleep or standby commands, which are issued when the drive transitions between power management states.)

ata_controller - Command %xreturned error

The command %x returned error. (%x is the opcode for the sleep or standby commands, which are issued when the drive transitions between power management states.)

ata_controller - Cannot take drive %d to sleep

The disk will not transition to sleep state. (Indicates that the driver could not set the device to sleep mode while performing power management functions.)

ata_controller - Cannot reset secondary/primary channel

The disk will not transition from sleep to active state.

These messages are informational and indicate that a timeout occured for a I/O request. The uata driver recovers from these states automatically unless there is a fatal error.

NAME | SYNOPSIS | DESCRIPTION | FILES | SEE ALSO | DIAGNOSTICS