Notable Fixes

Firmware revision 07.84.44.10 delivers the following fixes:

15704695 (CR 7030331)—6x80/2500_M2: Controller Summ pg IPv6 Routable Addresses do not display correct values

15759870 (CR 7119324)—3 leds (Service Allowed, Service Required, Power OK) are on controller PSU after power outage

15767160 (CR 7131261)—Error flag on failed write buffer incorrectly cleared, ultimately leading to ancient I/O

15778292 (CR 7152868)—Controller rebooted due to ASSERT: Assertion failed: lu, file hidDstDevice.cc, line 74

15818269 (CR 7200803)—2500M2/6x80 Write cache Enabled/Inactive after 2nd reinsertion of controller

15810254 (CR 7191711)—(symTask2): PANIC: Assertion failed: file cacheCacheMgr.cc, line 10071

15680299 (CR 6998633)—ESM/IOM cards may reboot and cause errors in eventlog

15720063 (CR 7051420—600G 15K SEAGATE SMART failure in appliance SN: 001115E0NAHH

15766957 (CR 7131010)—FW 0605 not in the upgrade path for ST330057SSUN300G and ST360057SSUN600G in CAM 6.9

15770825 (CR 7142578)—X4370M2 Seagate HDD high number of drive failures

15743119 (CR 7093236)—6x40: Write Cache remains disabled on one controller following ICC replacement.

15756478 (CR 7114196)—6x40/6x80: Controller reboots during drive swaps - FC for SATA or SATA for FC

15573171 (CR 6856441)—6x40: Tray loss protection compromised after adding capacity (drives) to a VG.

15761011 (CR 7121304)—6x40: Expanding the primary volume of an RVM pair causes both array controllers to go offline.

15778119 (CR 7152626)—2500LCA/6x40:Unable to reset battery near expiry via CAM due to non-GMT tz of mgt client

15791360 (CR 7168377)—6x80/6x40/2500-LCA/2500-M2:Unable to recover multi-bit ECC errors by reading from alt controller

15791363 (CR 7168380)—2500M2- SB ECC reporting not enabled after RPA scrub on snowmass

15792036 (CR 7169253)—2500M2/2500LCA/6x40/6x80: DDC didn't collect complete information after AIOs

15802541 (CR 7182597)—6x40/6x80 running 07.60.56.10 or lower code get 'unrecovered read' error but VDD does not recover it

15802542 (CR 7182598)—6x40/6x80 running 07.60.56.10 or lower code get 'unrecovered read' error but VDD does not recover it

15763203 (CR 7125089)—2500LCA/2500M2/6x80/6x40: 7.x code can suspend media scan without warning.

15810495 (CR 7191991)—Firmware E5C4 not in upgrade path in D_HUS1561FCSUN600G_E6C0.dlp with CAM 6.9.0_19

15691552 (CR 7012227)—write performance issue on Seagate disks

15695312 (CR 7017161)—Slow disk performance on Seagate ST32502N HDDs

Firmware revision 07.80.62.10 delivered the following fixes for Sun Storage 6180 arrays.

15763203 (CR 7125089)—2500LCA/2500M2/6x80/6x40: 7.x code can suspend media scan without warning.

15767948 (CR 7132372)—2500-m2/6180: rev07 battery failed during learn cycle

15769192 (CR 7134932)—2500-M2/6180: Incomplete battery learn cycle due to inhibit charge bit set

15791360 (CR 7168377)—6x80/6x40/2500-LCA/2500-M2:Unable to recover multi-bit ECC errors by reading from alt controller

15791363 (CR 7168380)—2500M2- SB ECC reporting not enabled after RPA scrub on snowmass

15792036 (CR 7169253)—2500M2/2500LCA/6x40/6x80: DDC didn't collect complete information after AIOs