Documentation, Support, and Training
Checking Logs and Error Messages
Display the Switch Message Log for Power Supplies
Display the Switch Message Log for Fabric Cards
Display the Switch Message Log for Line Cards
Understanding Signal Routing Through the Switch
CXP Connectors and LEDs to Line Card Switch Chip and Port Routes
Line Card Switch Chip to Line Card XBOW Connector Routes
Fabric Card XBOW Connector to Fabric Card Switch Chip Routes
Fabric Card Switch Chip to Fabric Card XBOW Connector Routes
Line Card XBOW Connector to Line Card Switch Chip Routes
Line Card Switch Chip and Port to CXP Connector and LED Routes
Signal Route Through the Switch
Understanding Switch Startup and Component Addition
Understanding ILOM on the Switch
The power supply status LEDs are located on the power supply at the front of the chassis.
Visually inspect the status LEDs.
Compare what is displayed on the power supply to the following table.
|
Caution - If a power supply has shut down because of a thermal or overcurrent condition, signified by the amber Attention LED lighting, remove the respective power cord from the chassis. Allow the power supply to completely cool for at least 15 minutes. Any less cooling time might cause damage to the power supply when the power cord is reattached. If the amber Attention LED lights upon reattaching the power cord, replace the power supply. |