Remote Management > Administering ILOM (CLI) > Monitoring ILOM Targets (CLI) > Verifying Other Aspects (CLI) |
Documentation, Support, and Training
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Switch From the ILOM Shell to the Linux Shell
Switch From the Linux Shell to the ILOM Shell
Display the Date, Time, and Time Zone (CLI)
Display the Aggregate Sensor State (CLI)
Display the ILOM Sessions (CLI)
Display the ILOM Event Log (CLI)
Checking the Status of Services (CLI)
Display the HTTP Service Status (CLI)
Display the HTTPS Service Status (CLI)
Display the SSL Certificates (CLI)
Display the SNMP Service Status (CLI)
Display the SNMP Service User Accounts (CLI)
Display the SNMP Service Communities (CLI)
Display the IPMI Service Status (CLI)
Get Help on an ILOM Command (CLI)
Get Help on an ILOM Target Property (CLI)
Display the ILOM User Accounts (CLI)
Display the Remote Log Hosts (CLI)
Display the Network Management Configuration (CLI)
Display the ILOM CLI Session Timeout (CLI)
Display Chassis FRU ID Information (CLI)
Display the ILOM Firmware Version (CLI)
Controlling ILOM Targets (CLI)
Performing General Tasks on ILOM Targets (CLI)
Set the Date, Time, and Time Zone (CLI)
Clear the ILOM Event Log (CLI)
Set the Remote Log Hosts (CLI)
Back Up the ILOM Configuration (CLI)
Restore the ILOM Configuration (CLI)
Set the Network Management Parameters (CLI)
Performing ILOM User Tasks (CLI)
Add an ILOM User Account (CLI)
Change an ILOM User's Password and or Role (CLI)
Delete an ILOM User Account (CLI)
Disable the HTTP Service (CLI)
Enable the HTTPS Service (CLI)
Install a Custom SSL Certificate (CLI)
Remove the Custom SSL Certificate (CLI)
Disable the HTTPS Service (CLI)
Configure the SNMP Service (CLI)
Add SNMP Service User Accounts (CLI)
Modify SNMP Service User Accounts (CLI)
Delete SNMP Service User Accounts (CLI)
Add SNMP Service Communities (CLI)
Modify SNMP Service Communities (CLI)
Delete SNMP Service Communities (CLI)
Back Up SNMP Service MIBs (CLI)
Disable the SNMP Service (CLI)
Enable Alerts to Send SNMP Traps (CLI)
Enable Alerts to Send PET (CLI)
Set the ILOM CLI Session Timeout (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Install the flint Application (CLI)
Download the Switch Firmware Package (CLI)
Set Component Firmware to Upgrade (CLI)
Upgrade the Switch Firmware (CLI)
Alerts can provide advance notice of a system failure. The ILOM implementation in the management controller supports 15 alert rules, which configure alert properties. Supported alert types are SNMP trap and PET. The alert destination must have the relevant ILOM MIBs installed and must support SNMP traps or PETs.
Access the ILOM CLI.
Display the alert properties:
-> show -d properties /SP/alertmgmt/rules/alert
where alert is the number of the alert to display.
For example, to display the properties for alert 1:
-> show -d properties /SP/alertmgmt/rules/1 /SP/alertmgmt/rules/1 Properties: community_or_username = public destination = 0.0.0.0 destination_port = 0 email_custom_sender = (none) email_message_prefix = (none) event_class_filter = (none) event_type_filter = (none) level = disable snmp_version = 1 testrule = (Cannot show property) type = snmptrap ->
Note - In the output, alert 1 is not configured to send any alerts.