Listing of rolechg_config

# 

# CDDL HEADER START

# 

#The contents of this file are subjected to the terms of the Common Development and Distribution 

#License (the License).

# You may not use this file except in compliance with the License.

#

# You can obtain a copy of the license at usr/src/CDDL.txt

# or http://www.opensolaris.org/os/licensing.

# See the License for the specific language governing permissions

# and limitations under the License.

#

# When distributing Covered Code, include this CDDL HEADER in each

# file and include the License file at usr/src/CDDL.txt.

# If applicable, add the following below this CDDL HEADER, with the

# fields enclosed by brackets [] replaced with your own identifying

# information: Portions Copyright [yyyy] [name of copyright owner] Use is subject to license terms.

#

# CDDL HEADER END

#





#

#Copyright 2008 Sun Microsystems, Inc.  All rights reserved.

# Use is subject to license terms.

# 



# ident   "@(#)rolechg_config.ksh 1.2     08/05/06 SMI"

#

# This file will be sourced in by rolechg_register and the parameters

# listed below will be used.

#

# These parameters can be customized in (key=value) form

#

#                  RS - name of the resource for the application.

#                  RG - name of the resource group containing RS.

#                PORT - name of the port number.

#                  LH - name of the LogicalHostname SC resource.

#                       Do not set the LH variable if you plan to have a network

#                       unaware installation.

#              HAS_RS - Name of the HAStoragePlus SC resource.

#            STDBY_RS - The resource name of designated standby database

#              PRI_RS - The resource name of designated primary database

#          STDBY_HOST - Hostname  or zonename of the standby host. If empty, a role switch

#                       will be initiated on any host.

#          SDBY_PFILE - Parameter file which contains the PostgreSQL specific

#                       parameters for the standby database. This file is mentioned in

#                       the Start_command of the PostgreSQL standby resource.

#             TRIGGER - The filename which will get created to tell pg_standby to end the

#                       recovery mode, this filename is mentioned in the recovery.conf file

#                       of the PostgreSQL standby database.

#                WAIT - The number of seconds the start method waits before it touches

#                       the trigger file. This little break is necessary because, if the

#                       trigger file should be touched before, or in the middle of the

#                       PostgreSQL start process, it would get removed automatically.



RS=

RG=

PORT=

LH=

HAS_RS=

STDBY_RS=

PRI¯_RS=

STDBY_HOST=

STDBY_PFILE=

TRIGGER=

WAIT=