Flash Module Architecture Overview
Energy Storage Module Overview
Perform ESD Prevention Measures
(Optional) Install Full-Height Bracket
Install the Card Into a System
FMod Alignment for Optimal Performance
(Optional) Using the SAS/SATA Controller as a Boot Device
SAS/SATA Controller as a Boot Device
Configure the SAS/SATA Controller as a Boot Device (SPARC Systems)
Configure the SAS/SATA Controller as a Boot Device (x86 Systems)
Replacing FMod Retention Clips
Monitoring ESM Lifespan Options
Sun Flash Accelerator F20 ESM Monitoring Utility
Oracle ILOM ESM Monitoring for SPARC T-Series Servers
Oracle ILOM ESM Monitoring for x86 X Series Servers
XSCF ESM Monitoring for SPARC M Series Servers
Remove the ESM (Alternate Configuration)
Update the FMod Firmware (Oracle Solaris OS)
Update the FMod Firmware (Windows and Linux OS)
Updating the SAS/SATA Controller Firmware
Update the SAS/SATA Controller Firmware (Oracle Solaris OS)
Update the SAS/SATA Controller Firmware (Linux OS)
Before You Begin
Before you begin, perform the following task:
See Remove an FMod.
Route the ESM cable around the retainer clip so that the cable will lay between FMod0 and FMod1.
See Install an FMod
For instructions, see the service manual and the product notes for your system.
See Card LEDs.