A key variable in this situation is ufs_ninode. This parameter is used to compute two key limits that affect the handling of inode caching. A high watermark of ufs_ninode / 2 and a low water mark of ufs_ninode / 4 are computed.
When the system is done with an inode, one of two things can happen:
The file referred to by the inode is no longer on the system so the inode is deleted. After it is deleted, the space goes back into the inode cache for use by another inode (which is read from disk or created for a new file).
The file still exists but is no longer referenced by a running process. The inode is then placed on the idle queue. Any referenced pages are still in memory.
When inodes are idled, the kernel defers the idling process to a later time. If a file system is a logging file system the kernel also defers deletion of inodes. Two kernel threads do this. Each thread is responsible for one of the queues.
When the deferred processing is done, the system drops the inode onto either a delete or idle queue, each of which has a thread that can run to process it. When the inode is placed on the queue, the queue occupancy is checked against the low watermark. If it is in excess of the low watermark, the thread associated with the queue is awakened. After it is awakened, the thread runs through the queue and forces any pages associated with the inode out to disk and frees the inode. The thread stops when it has removed 50% of the inodes on the queue at the time it was awakened.
A second mechanism is in place if the idle thread is unable to keep up with the load. When the system needs to find a vnode, it goes through the ufs_vget routine. The first thing vget does is check the length of the idle queue. If the length is above the high watermark, then it pops two inodes off the idle queue and “idles” them (flushes pages and frees inodes). It does this before it gets an inode for its own use.
The system does attempt to optimize by placing inodes with no in-core pages at the head of the idle list and inodes with pages at the end of the idle list, but it does no other ordering of the list. Inodes are always removed from the front of the idle queue.
The only time that inodes are removed from the queues as a whole is when a sync, unmount, or remount occur.
For historical reasons, this parameter does not require the ufs: prefix.
0 to MAXINT
If ufs_ninode is less than or equal to zero, the value is set to ncsize.
When the default number of inodes is not enough. If the maxsize reached field as reported by kstat -n inode_cache is larger than the maxsize field in the kstat, the value of ufs_ninode may be too small. Excessive inode idling (described previously) can also be a problem.
This situation can be identified by using kstat -n inode_cache to look at the inode_cache kstat. Thread idles are inodes idled by the background threads while vget idles are idles by the requesting process before using an inode.