How to Enable or Disable Read or Write Protection and a Password on Iomega Media

You can apply a password with a maximum of 32 characters for Iomega media that support this feature. You cannot set read protection or write protection without a password on Iomega media. In this situation, you are prompted to provide a password.

You receive a warning message if you attempt to apply a password on media that does not support this feature.

Steps

1. Determine whether you want to enable or disable read protection or write protection and a password.

   1. Enable read protection or write protection.

      $ rmformat -W enable device-name Please enter password (32 chars maximum): xxx Please reenter password:

      $ rmformat -R enable device-name Please enter password (32 chars maximum): xxx Please reenter password:

   2. Disable read protection or write protection and remove the password.

      $ rmformat -W disable device-name Please enter password (32 chars maximum): xxx

      $ rmformat -R disable device-name Please enter password (32 chars maximum): xxx

2. Verify whether the media's read protection or write protection is enabled or disabled.

   $ rmformat -p device-name

Example 3–6 Enabling or Disabling Read or Write Protection

This example shows how to enable write protection and set a password on a Zip drive.

$ rmformat -W enable /vol/dev/aliases/zip0
Please enter password (32 chars maximum): xxx
Please reenter password: xxx

This example shows how to disable write protection and remove the password on a Zip drive.

$ rmformat -W disable /vol/dev/aliases/zip0
Please enter password (32 chars maximum): xxx

This example shows how to enable read protection and set a password on a Zip drive.

rmformat -R enable /vol/dev/aliases/zip0
Please enter password (32 chars maximum): xxx
Please reenter password: xxx

This example shows to disable read protection and remove the password on a Zip drive.

$ rmformat -R disable /vol/dev/aliases/zip0
Please enter password (32 chars maximum): xxx