This section describes the Sun Cluster HA for SWIFTAlliance Access fault monitor's probing algorithm or functionality, and states the conditions, messages, and recovery actions associated with unsuccessful probing.
For conceptual information on fault monitors, see the Sun Cluster Concepts Guide.
The Sun Cluster HA for SWIFTAlliance Access fault monitor uses the same resource properties as resource type SUNW.gds, refer to the SUNW.gds(5) man page for a complete list of resource properties used.
By default, the HA agent provides a fault monitor for the DCE component only when using SWIFTAlliance Access 5.5. The fault monitoring for SWIFTAlliance Access is switched off by default. If the SWIFTAlliance Access application fails, the agent will not restart the SWIFTAlliance Access application automatically. This behavior was explicitly requested by SWIFT. It will enable you to operate the application in a way that the probe does not interfere with the normal behavior of some SWIFTAlliance Access features like:
operator manually triggering the SWIFTAlliance Access restart function , for example, to run SWIFTAlliance Access in housekeeping mode.
automatic or scheduled SWIFTAlliance Access restart, for example, to run database backup and other maintenance or end-of-day processes.
any graceful SWIFTAlliance Access restart or recovery, in case of a SWIFTAlliance Access transient local error.
The HA agent will update the resource status message to output Degraded - SAA Instance offline.
If an automatic failover occurs with default setting, it is most likely that there was a DCE problem. The SWIFTAlliance Access application will cause a failover only when it does not start on the current node.
The HA agent provides an option to turn on fault monitoring for SWIFTAlliance Access at registration time. However, this option is not recommended by SWIFT. The optional probing checks for the existence of the SWIFTAlliance Access instance by calling the alliance command that is part of the application and by evaluating its return code. If the SWIFTAlliance Access instance is not running, return code 100 is sent to SUNW.gds, which in turn will perform an automatic restart depending on the configuration of the resource properties.