JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Storage F5100 Flash Array Topic Set
search filter icon
search icon

Document Information


Related Documentation

Documentation, Support, and Training

Documentation Feedback


Installing the System

Preparing for Installation

Verify System Components

Tools Required

Safety Requirements

Prepare the Data Host

Reviewing Front and Rear Panels

Front Panel Diagram

Rear Panel Diagram

Rackmounting the System

Install the System With the Express Rail Kit

(Optional) Install the System With the Standard Rail Kit

(Optional) Install the Cable Management Arm (CMA)

Remove the System From the Rack

Remove the Express Slide Rails from the Rack

Remove the Standard Slide Rails from the Rack

Cabling the System

Configuring the System

Connectivity Terms

General Connectivity Rules

Connecting to Host Bus Adapters (HBAs)

Connect the Power Cords

(Optional) Install the Power Cord Retainer

Power On

Managing the System

Sun Storage CAM Software

Firmware Updates

Access Configuration (Zoning) Support

Access Configuration (Zoning) Guidelines

SATA Affiliation

Power Off


Sun Storage F5100 Flash Array Overview


Replaceable Components

Hot-Swappable Components

Obtaining the Chassis Serial Number

Diagnosing System Faults

Choosing a Method for Diagnosing Faults

Diagnosing Faults With Sun StorageTek Common Array Manager Software

Diagnosing Faults With LEDs and Indicators

Troubleshooting Components

Preparing to Service the System

Safety Information

Service Preparation Reference

Powering the System Off

Performing an Antistatic Discharge

Positioning the Chassis

Accessing Internal Components

Replacing System Components

Component Overview

Customer-Replaceable and Field-Replaceable Components

Replacing Flash Modules

Replacing a Fan Module

Replacing a Power Supply

Replacing an Energy Storage Module

Replacing Fan Boards

Replacing the Motherboard Assembly

Replacing a Power Distribution Board

Replacing the Connector Board Assembly

Replacing the Energy Storage Backplane

Returning the System to Service

Replace the Top Chassis Cover

Install the Chassis to Maintenance Position

Return the System to the Fully Installed Position

Install AC Power Cord Retention Clips

Power On the System


Remove the System From the Rack


Caution - Stabilize the cabinet: extend the rack anti-tip device.

Before You Begin

Before you begin, remove the cable management arm, if present, and detach all cables from the system.

  1. Squeeze the green buttons on the face of the glides to release the system, and then pull to fully extend the system.
  2. Slide the gray release tab, on the slide rail, forward to disconnect the system from the rack.

    Figure 4 Removing the System from the Rack

    Image showing how to remove the syste,m from the rack.
  3. Remove the system from the rack.
Related Information