| Skip Navigation Links | |
| Exit Print View | |
|
Sun Blade X6275 M2 Server Module Service Manual |
About This Documentation (PDF and HTML)
Server Module and Components Overview
About the Sun Blade 6000 Modular System Chassis
Powering On and Off the Server Module
Preparation Procedures for Service and Operation
Preparing the Server for Service
Preparing the Server for Operation
Component Removal and Installation Procedures
Removing and Installing Flash Modules
Removing and Installing the Energy Storage Modules
Removing and Installing the Service Processor Board
Removing and Installing USB Flash Drives
Removing and Installing a CPU and Heatsink Assembly
How to Remove a CPU and Heatsink Assembly
How to Install a CPU and Heatsink Assembly
How to Replace the Motherboard Assembly
Diagnostic and Maintenance Information and Procedures
Diagnosing Server Module Hardware Faults
BIOS Power-On Self-Test (POST) Codes
Server Module Maintenance Procedures and Information
Use this procedure to identify a faulty CPU.
Before You Begin
For the location of the CPU and heatsink assemblies, see Illustrated Parts Breakdown.
For information about using the CPU test circuit, see Using the DIMM and CPU On-Board Test Circuitry.
Note - Do not hold the Fault Remind button down longer than necessary.
As indicated in the following table, a failed processor is identified by a lit Processor Fault LED.
|
Next Steps
|