About This Documentation (PDF and HTML)
Overview of the Sun Blade X6275 M2 Server Module Product Notes
System Software Release Features
Integrated Lights Out Manager (ILOM)
Hardware, Firmware, and BIOS Issues
Hardware, Firmware, and BIOS Current Issues
Management and ILOM Current Issues
Capping Power Values in ILOM Web Interface
Reading Server Power Consumption in the CMM
The Server Will Not Boot if the CMM is Off-Line
Set Port Sharing Error Message Generated When Using SP ILOM Web Interface (6895495)
Green LED Should Slow Blink (1 Hz) During Firmware Upgrade (6862377)
IPMIflash Over USB Interface Fails Due to Unexpected Response to File-upload Command (6856369)
Missing Warning Message While Doing Backup Configuration Without Passphrase (6859295)
Erroneous Chassis Hot Insertion Event Logged After CMM Reboot (6797938)
CMM ILOM Becomes Unresponsive With Multiple CLI Sessions Open (6780171)
CMM ILOM Interface Becomes Unresponsive After Repeated Use (6798257)
Blade Power On Issues With the start /SYS Command (6784708)
SP Network Connection Lost When Issuing Incorrect ipmiflash -I pci Command (6850823)
Powering On Batches of Blades Might Cause a Node to Fail to Power On (6813202)
Softcap Power Limiting Does Not Work When the Host is Powered on After the SP Reboots (6890841)
PCIe EM Native Hot Plug Does Not Work (6804272)
ILOM Power Budget Status Does Not Function Properly When Disabled and Then Enabled (7009654)
ILOM Configurations Are Preserved During Upgrade Even After Specifying "No" (6971164)
According to the IPMI specification, the locate LED on the front of the blade is supposed to turn itself off after 15 seconds. However, Oracle has determined that this might not give the customer sufficient time to physically locate the system. For this reason, Oracle has chosen to deviate from the IPMI specification and set the default time-out value to 30 minutes.
You can choose to turn the locate LED off at any time using one of the following methods:
Turn off the locate LED manually by pressing locate button on the blade.
Use the ILOM web interface or CLI to turn off the locate LED.
Use the IPMItool chassis identify command to turn off the locate LED by setting the time-out value to zero.
Wait 30 minutes for the locate LED to automatically turn off on its own.