JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Blade X6275 M2 Server Module Product Documentation
search filter icon
search icon

Document Information

Using This Documentation

Product Information Web Site

Related Books

About This Documentation (PDF and HTML)

Documentation Comments

Contributors

Change History

Hardware Installation and Product Notes

Hardware Installation

Overview of the Sun Blade X6275 M2 Server Module

Installing and Powering On the Server Module

Setting Up ILOM

Installing a Supported OS

Product Notes

Overview of the Sun Blade X6275 M2 Server Module Product Notes

System Software Release Features

Firmware Release History

Supported Hardware

Supported Operating Systems

Integrated Lights Out Manager (ILOM)

Additional Software

Hardware, Firmware, and BIOS Issues

Hardware, Firmware, and BIOS Current Issues

Care and Handling of Server Modules with FMods

Setup and Power-On Recommendations for the Sun Blade 6000 Modular System Chassis

PCIe Link Speed Reduced With BIOS 10.2.6.0 (6994690)

PC-Check 6.27s Does Not Recognize Mellanox 10GbE Chip (6992284)

Performance Degradation When BIOS Hardware Prefetcher is Enabled

Identifying a Node's Onboard Device Versus a Node's PCIe EM (7072665)

Management and ILOM Issues

Management and ILOM Current Issues

Capping Power Values in ILOM Web Interface

Reading Server Power Consumption in the CMM

The Server Will Not Boot if the CMM is Off-Line

Locate LED Programmed to Stay On for 30 Minutes (6793865)

Set Port Sharing Error Message Generated When Using SP ILOM Web Interface (6895495)

Green LED Should Slow Blink (1 Hz) During Firmware Upgrade (6862377)

IPMIflash Over USB Interface Fails Due to Unexpected Response to File-upload Command (6856369)

Missing Warning Message While Doing Backup Configuration Without Passphrase (6859295)

Erroneous Chassis Hot Insertion Event Logged After CMM Reboot (6797938)

Setting the Serial Baud Rate in the System BIOS Does Not Propagate to the Service Processor (6784341)

CMM ILOM Becomes Unresponsive With Multiple CLI Sessions Open (6780171)

CMM ILOM Interface Becomes Unresponsive After Repeated Use (6798257)

Blade Power On Issues With the start /SYS Command (6784708)

SP Network Connection Lost When Issuing Incorrect ipmiflash -I pci Command (6850823)

Powering On Batches of Blades Might Cause a Node to Fail to Power On (6813202)

Softcap Power Limiting Does Not Work When the Host is Powered on After the SP Reboots (6890841)

PCIe EM Native Hot Plug Does Not Work (6804272)

Resetting the SP to Factory Defaults With Host Powered On Causes DIMM FRU Information to Be Lost (6970476, 6913602)

ILOM Power Budget Status Does Not Function Properly When Disabled and Then Enabled (7009654)

ILOM Configurations Are Preserved During Upgrade Even After Specifying "No" (6971164)

Linux Issues

Linux Current Issues

Setting the Power Management Hardcap Power Limit Prior to Booting the System Does Not Control System Power

OL/RHEL: Setting the Power Management Hardcap Power Limit Prior With the Host Power Off Does Not Control System Power (7009666)

OL/RHEL Error Message: PCI: BIOS Bug MCFG area at e0000000 is not E820-reserved

OL/RHEL Sound Server Informational Message: Error While Initializing the Sound Driver

SLES: Additional Software Driver Added May Not Work

SLES Error Message: Hotpluggable processor device is not present

SLES: 10GbE Driver Does Not Load Automatically During Boot (6994464)

Oracle Solaris Issues

Oracle Solaris Current Issues

Setting the Power Management Hardcap Power Limit Prior to Booting the System Does Not Control System Power

Windows Issues

Windows Current Issues

The Sun Quad Gigabit Ethernet PCIe EM (X7284A-Z) Does Not Support Hot-Plug in Windows Server 2008 (6793369)

Configuring the 10GbE Driver for Maximum Performance Can Cause Windows Blue Screens (7010601)

Documentation Issues

Documentation Current Issues

Getting Started Guide Contains Incorrect Power LED State Information

Operating System Installation

Oracle Solaris Installation

Installing the Oracle Solaris Operating System

Linux Installation

Preparing to Install an OS

Installing Oracle Linux

Installing Red Hat Enterprise Linux

Installing the SLES Operating System

Oracle VM Installation

Introduction to Oracle VM Installation

Installing Oracle VM

Creating a PXE Installation Image for Oracle VM

Windows Installation

Introduction to Windows Installation

Getting Started With Windows Server 2008 Installation

Downloading Server Software

Installing the Windows Server 2008 R2 Operating System

Updating Critical Drivers and Installing Supplemental Software

Incorporating Device Drivers into a WIM Image for WDS

Administration, Diagnostics, and Service

ILOM Supplement

Overview of the ILOM Supplement

Introduction to Oracle ILOM

Managing Power Usage and Monitoring Power Consumption

Configuring the Server Power Restore Policy

Switching the Default Serial Port Output Between SP and Host Console

Updating Firmware

Using the ILOM Preboot Menu

Indicators, Sensors, and Traps

Diagnostics Guide

Preface

Diagnostics Guide

Introduction to Diagnostic Tools

U-Boot Diagnostic Startup Tests

Pc-Check Diagnostics Utility

Accessing the Pc-Check Diagnostics Utility on the Tools and Drivers CD/DVD

Service Manual

Service Manual Overview

Server Module and Components Overview

Power and Reset

Preparation Procedures for Service and Operation

Component Removal and Installation Procedures

Diagnostic and Maintenance Information and Procedures

Specifications

Index

SP Network Connection Lost When Issuing Incorrect ipmiflash -I pci Command (6850823)

The correct command for running ipmiflash -I pci is:

ipmiflash -I pci write ILOM.pkg :: --platform-type vayu_QDR_IB --id-num 38 -l 0xa0000


Note - The double colons (“::”) are required in this command.


IPMIflash is not currently supported for use with the Sun Blade X6275 M2 server module. When support becomes available, these product notes will be updated.