About This Documentation (PDF and HTML)
Hardware Installation and Product Notes
Overview of the Sun Blade X6275 M2 Server Module
Installing and Powering On the Server Module
Overview of the Sun Blade X6275 M2 Server Module Product Notes
System Software Release Features
Hardware, Firmware, and BIOS Issues
Installing the Oracle Solaris Operating System
Installing Red Hat Enterprise Linux
Installing the SLES Operating System
Introduction to Oracle VM Installation
Creating a PXE Installation Image for Oracle VM
Introduction to Windows Installation
Getting Started With Windows Server 2008 Installation
Supported Windows Operating Systems
Windows Installation Considerations
Windows Media Delivery Methods
How to Download Server Software
Installing the Windows Server 2008 R2 Operating System
How to Install Windows Server 2008 R2 Using Local or Remote Media
Updating Critical Drivers and Installing Supplemental Software
Installing Server-Specific Device Drivers
How to Install the Server-Specific Device Drivers
Installing Supplemental Software
Incorporating Device Drivers into a WIM Image for WDS
How to Add Drivers to the WIM Image
How to Install Windows Server 2008 R2 Using PXE
Administration, Diagnostics, and Service
Overview of the ILOM Supplement
Managing Power Usage and Monitoring Power Consumption
Configuring the Server Power Restore Policy
Switching the Default Serial Port Output Between SP and Host Console
Indicators, Sensors, and Traps
Introduction to Diagnostic Tools
U-Boot Diagnostic Startup Tests
Accessing the Pc-Check Diagnostics Utility on the Tools and Drivers CD/DVD
Server Module and Components Overview
Preparation Procedures for Service and Operation
Component Removal and Installation Procedures
Before You Begin
If you have already installed the supplemental software, running the installation again will not necessarily reinstall the supplemental software. It might result in the components being removed. Carefully review the dialog boxes during supplemental software installation to ensure that the results are as expected.
If you did not select the Supplemental software when you ran the procedure described in Installing Server-Specific Device Drivers, run it again, but this time accept the default settings and select No.
The Supplemental Software dialog box appears. Proceed to the next step.
If you did select Supplemental software, and selected No, the following dialog box appears. Proceed to the next step.
The Component installation wizard will guide you through the installation of each of the selected supplemental software components.
If you ran the Installation Package software from the Tools and Drivers DVD, remove the DVD from your system now.