About This Guide |
This Sun Storage 2500-M2 Arrays Hardware Installation Guide describes how to install array trays in a cabinet, physically set up and connect your array to a host, apply power and to add network functionality, including storage management (multipath/failover), IP addressing, and DHCP.
The terminology used in this document refers to the Sun Storage 2500-M2 Arrays. There are two styles of controller trays, each with different host interface ports (SAS or FC). There is also the expansion tray, which enables the Sun Storage 2500-M2 Arrays to have more disk drives attached. The components that slide into the trays are called customer replaceable units (CRUs) or modules.
Array management, data host management, and remote command line interface (CLI) functions are performed by the Sun Storage Common Array Manager (CAM) software. For installation and initial configuration of the array, including firmware upgrades, initial array setup, partitioning domains, configuring storage, and configuring IP addressing, see the Sun Storage Common Array Manager Installation and Setup Guide.
Refer to the following documents to make sure physical dimensions, service clearances, and power connections are ready for the installation of the array.
These web sites provide additional resources:
Copyright © 2011, Oracle and/or its affiliates. All rights reserved.