JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Server X2-8 (formerly Sun Fire X4800 M2) Rackmounting Hardware Installation Guide     Sun Server X2-8 (formerly Sun Fire X4800 M2) Documentation Library
search filter icon
search icon

Document Information

Using This Documentation

Sun Server X2-8 Name Change

Product Downloads

Documentation and Feedback

About This Documentation

Change History

Introduction to Rack Mounting Hardware Installation

How to Identify Your Rack Mounting Kit

How to Unpack the Server

Installing the Server In the Rack Using the Standard Rack Mounting Kit

Tools and Staff Required

Installing Optional Equipment

Compatible Racks

Contents of the Standard Rack Mounting Kit

Location of the Rack Mounting Kit and the Shipping Bracket Kit

Installing the Server In a Rack Using the Standard Rack Mounting Kit

Removing and Installing the Standard Rack Mounting Kit Shipping Brackets

Installing the Server in the Rack Using the Universal Rack Mounting Kit

Tools and Staff Required

Installing Optional Equipment

Compatible Racks

Contents of the Universal Rack Mounting Kit

Installing the Server in a Rack Using the Universal Rack Mounting Kit

How to Remove Components to Reduce Weight

How to Replace the Components in the Server

How to Install the Universal Rack Mounting Hardware in a Square-Hole Rack

How to Install the Universal Rack Mounting Hardware in a Round-Hole Rack

How to Insert the Server Into the Rack

Installing and Removing the Universal Rack Mounting Kit Shipping Brackets

How to Install the Universal Rack Mounting Kit Shipping Brackets

How to Remove the Universal Rack Mounting Kit Shipping Brackets

How to Insert the Server Into the Rack

Before You Begin

Perform the steps in How to Install the Universal Rack Mounting Hardware in a Round-Hole Rack.

  1. Lift the server to its position in the rack.

    The use of a mechanical lift is recommended.


    Caution

    Caution - The server weighs 180 pounds (82 kg). To reduce the risk of serious personal injury or equipment damage, use a mechanical lift to install the server into the rack. If a lift is not available, remove components as instructed in How to Remove Components to Reduce Weight, and use two persons to lift the server into place.


  2. Slide the server onto the shelf rails.

    Caution

    Caution - Drop Hazard! Do not release the server until it is 12 inches (304 mm) into the rack, and is firmly supported by the shelf rails. The shelf rails can not support the server until it is 12 inches (304 mm) inside the rack.



    Note - If the server is still on a pallet, you can leave it on the pallet and lift both the server and the pallet with the mechanical lift, and slide the server off the pallet and onto the shelf rails.



    image:Picture of lift inserting server into rack
  3. Use four screws to attach the front bezel of the server to the front of the rack, as shown in the following figure.
    • For square-hole racks, use four M6 x 16 screws.

    • For round-hole racks, use four M6 x 12, or four 10-32 x 10 screws.


    Note - On square-hole racks, the screws pass through the rack and thread into the adapter bracket. On round-hole racks, the screws thread into the rack rails.



    image:Attaching the chassis to the rack
  4. Move the rear braces so they are snug against the server chassis. See the following figure.

    From the rear of the system:

    1. Loosen the screws (1).
    2. Slide the braces down (2).
    3. Tighten the screws (1).

    image:Adjusting rear braces
  5. If you removed components from the server, replace them after the server is mounted in the rack. See How to Remove Components to Reduce Weight.

See Also

How to Remove Components to Reduce Weight