Skip Headers
Oracle® WebLogic Communication Services Installation Guide
11g Release 1 (11.1.1)

Part Number E13808-02
Go to Documentation Home
Go to Book List
Book List
Go to Table of Contents
Go to Index
Go to Master Index
Master Index
Go to Feedback page
Contact Us

Go to previous page
Go to next page
View PDF

6 Post-Installation

This chapter describes post-installation steps for Oracle WebLogic Communication Services (OWLCS). It contains the following topics:

6.1 Changing Realm from

The out-of-the-box realm ( should be changed to reflect the realm or domain of your deployment. Make these modifications to the realm or domain:

6.2 Provisioning Third-Party Call Control (TPCC) Users to Enable Third Party Call Control

Authentication for INVITE requests initiated by Third Party Call Control is accomplished by inserting a P-Asserted Identity Header in the request by the Third Party Call Control application. By default, the PAssertedIdentityURI is set to; for authentication to be successful, you must create and provision the corresponding TPCC user. To create and provision the user:

  1. Use Sash to issue the following command:

    identity add privateId=tpcc.user role="Location Service"
  2. Enter a password of your choice when prompted (this password is not part of TPCC configuration, so an actual value is not used anywhere).

  3. Ensure you replace with the realm or domain for your installation. Third Party Call Control will not work if the above user is not created and provisioned.


For more information on provisioning users and using Sash, see Oracle WebLogic Communication Services Administrator's Guide.