Caution - Support the CMA during this installation. Do not allow the assembly to hang by its own weight until it is secured by all three attachment points.
At the rear of the rack, plug the CMA rail extension into the end of the left sliding rail assembly. The tab at the front of the rail extension clicks into place.
Figure 14 Inserting the CMA Rail Extension Into the Rear of the Left Slide Rail
The right sides of the two CMA arms have hinged extensions. On the manufacturer's instruction sheet, the smaller extension is called the CMA Connector for Inner Member. This extension attaches to the right mounting bracket. The larger extension is called the CMA Connector for Outer Member, and attaches to the right sliding rail.
Slide the smaller extension into the square hole on the middle-in-width of the clip that is located at the end of the mounting bracket.
Figure 15 Mounting the Inner CMA Connector
Figure 16 Attaching the Outer CMA Connector
The plastic tab on the CMA rail extension locks the hinged plastic connector in place.
Figure 17 Mounting the Left Side of the Slide Rail