| Skip Navigation Links | |
| Exit Print View | |
|
Oracle Solaris 10 8/11 Installation Guide: Network-Based Installations Oracle Solaris 10 8/11 Information Library |
| Skip Navigation Links | |
| Exit Print View | |
|
|
Oracle Solaris 10 8/11 Installation Guide: Network-Based Installations Oracle Solaris 10 8/11 Information Library |
Part I Planning to Install Over the Network
1. Where to Find Oracle Solaris Installation Planning Information
2. Preconfiguring System Configuration Information (Tasks)
3. Preconfiguring With a Naming Service or DHCP
Part II Installing Over a Local Area Network
4. Installing From the Network (Overview)
5. Installing From the Network With DVD Media (Tasks)
6. Installing From the Network With CD Media (Tasks)
7. Patching the Miniroot Image (Tasks)
8. Installing Over the Network (Examples)
9. Installing From the Network (Command Reference)
Part III Installing Over a Wide Area Network
11. Preparing to Install With WAN Boot (Planning)
12. Installing With WAN Boot (Tasks)
13. SPARC: Installing With WAN Boot (Tasks)
14. SPARC: Installing With WAN Boot (Examples)
Problems With Setting Up Network Installations
Problems With Booting a System
Booting From Media, Error Messages
Booting From Media, General Problems
Booting From the Network, Error Messages
Booting From the Network, General Problems
x86: To Check IDE Disk for Bad Blocks
Upgrading the Oracle Solaris OS
To Continue Upgrading After a Failed Upgrade
x86: Problems With Live Upgrade When You Use GRUB
System Panics When Upgrading With Live Upgrade Running Veritas VxVM
x86: Service Partition Not Created by Default on Systems With No Existing Service Partition
To Install Software From a Network Installation Image or From the Oracle Solaris DVD
To Install From the Oracle Solaris Software - 1 CD or From a Network Installation Image
Initial installation fails
Solution: If the Oracle Solaris installation fails, you must restart the installation. To restart the installation, boot the system from the Oracle Solaris DVD, the Oracle Solaris Software - 1 CD, or from the network.
You cannot uninstall the Oracle Solaris software after the software has been partially installed. You must restore your system from a backup or begin the Oracle Solaris installation process again.
/cdrom/sol_Solaris_10/SUNWxxxx/reloc.cpio: Broken pipe
Description: This error message is informational and does not affect the installation. The condition occurs when a write on a pipe does not have a reading process.
Solution: Ignore the message and continue with the installation.
WARNING: CHANGE DEFAULT BOOT DEVICE (x86 based systems only)
Cause: This is an informational message. The default boot device set in the system's BIOS might be set to a device that requires you to use the Oracle Solaris Device Configuration Assistant to boot the system.
Solution: Continue with the installation and, if necessary, change the system's default boot device specified in the BIOS after you install the Oracle Solaris software to a device that does not require the Oracle Solaris Device Configuration Assistant.
x86 only - If you are using the locale keyword to test a custom JumpStart profile for an initial installation, the pfinstall -D command fails to test the profile. For a workaround, see the error message “could not select locale,” in the section, Upgrading the Oracle Solaris OS.
|