For more information, see Section 9.3, "JMX Management".
Using the Oracle CEP Visualizer, you can view JMX configuration.
In the left pane, click the Domain > Server node, where Domain refers to the name of your Oracle CEP domain and Server refers to the name of the server instance.
In the right pane, click the JMX tab.
The JMX tab appears as Figure 12-1 shows.
The JMX properties are displayed in the table:
jndi-service-name—The name of the JNDI service to which the JMX server will bind its object.
rmi-service-name—The name of the RMI service with which the JMX server will register to receive calls.
rmi-jrmp-port—The port on which to listen for RMI JRMP JMX requests.
rmi-registry-port—The port on which to start the RMIRegistry.
Oracle CEP does not support the JRMP protocol: an Oracle CEP JMX client does not use the
rmi-registry-port properties. Instead, JMX clients must use the more secure MSA protocol for both local and remote access to the Oracle CEP JMX server. When you connect to the Oracle CEP JMX server that is running on
localhost or on a remote host, you must always use the JMX URL
/jndi/jmxconnector so that you are always using the MSA connector (where
HOST-NAME is either
localhost or the name of the remote host and
PORT is the Oracle CEP server JNDI port). For more information, see "Accessing the Oracle CEP JMX Server" in the Oracle Fusion Middleware Administrator's Guide for Oracle Complex Event Processing.
For more information, see "Configuring JMX for Oracle CEP" in the Oracle Fusion Middleware Administrator's Guide for Oracle Complex Event Processing.