You can configure the following fields in the Routing Wizard:
URL:
Enter the full URL of the destination Web Service. The host,
port, and scheme (HTTP or HTTPS) are extracted from the URL and used to configure
a Static Router filter.
Proxy Host:
If you want to send the request using an HTTP proxy, configure the Proxy
Host and Proxy Port. In this case, the Static
Router filter is configured with the host and port entered in these fields.
The Connection filter sends the complete URL specified in the
URL field as the request URI to the proxy, as required by the HTTP
specification. The proxy then knows where to route the message on to.
Note:
If the Proxy Host and Proxy Port fields are completed,
the wizard automatically selects the Send via proxy field on the
Advanced tab of the auto-generated Connection filter.
Proxy Port:
If you want to route messages using a proxy to the destination Web Service, enter the
port on the Proxy Host specified above on which the proxy accepts requests.
SSL Port:
If the proxy is SSL-enabled, enter the SSL port in this field.
Trusted Certificates, Client SSL Authentication, and HTTP Authentication Tabs
The settings configured on the remaining tabs of the wizard correspond to the settings
configured on the tabs displayed on the Connection filter. For more
information on configuring the fields on these tabs, see the
Connection topic.
|