Remove a Power Supply
The power supply is a hot-service component that can be replaced by a customer.
 | Caution - This procedure requires that you handle components that are sensitive to electrostatic discharge. This discharge can cause failure of server components. |
- Locate
the power supply that you want to remove.
- See Front Panel Components for the locations of the power supplies in the server.
- See Determine Which Power Supply Is Faulty to locate a faulty power supply.
- Go to the rear of the server and locate the AC power connector at the rear of the server that supplies power to the faulty power supply.
- Disconnect that power cord.
- Go to the front of the server
and, on the power supply to be removed, squeeze the release latches
together, then pull the extraction lever toward you to disengage
the power supply from the server.
- Pull the power supply out of
the server.
- Install the replacement power supply.