Go to main content

SPARC T5-1B Server Module Service Manual

Exit Print View

Updated: February 2019
 
 

Run POST With Maximum Testing

Use this procedure to configure the server module to run the maximum level of POST.

If you are accessing the server module through the CMM, prepend each target path with /Servers/Blades/Blade_n, where n is the slot in which the server module is installed. For example, set /HOST keyswitch_state=diag should be entered as set /Servers/Blades/Blade_n/HOST keyswitch_state=diag.

  1. Log into Oracle ILOM.

    See Log Into Oracle ILOM (Service).

  2. Set the virtual keyswitch to diag so that POST runs in service mode.
    -> set /HOST keyswitch_state=diag
    Set keyswitch_state to 'Diag'
    
  3. Reset the server so that POST runs.

    There are several ways to initiate a reset. This example shows a reset using the reset command.

    -> reset /System
    Are you sure you want to reset /System (y/n)? y
    Resetting /System
    

Related Information