Creating Default Services

The following virtual device services must be created to use the control domain as a service domain and to create virtual devices for other domains:

vcc – Virtual console concentrator service
vds – Virtual disk server
vsw – Virtual switch service

How to Create Default Services

Create a virtual console concentrator (vcc) service for use by the virtual network terminal server daemon (vntsd) and as a concentrator for all logical domain consoles.
For example, the following command would add a virtual console concentrator service (primary-vcc0) with a port range from 5000 to 5100 to the control domain (primary).
```
primary# ldm add-vcc port-range=5000-5100 primary-vcc0 primary
```
Create a virtual disk server (vds) to allow importing virtual disks into a logical domain.
For example, the following command adds a virtual disk server (primary-vds0) to the control domain (primary).
```
primary# ldm add-vds primary-vds0 primary
```
Create a virtual switch service (vsw) to enable networking between virtual network (vnet) devices in logical domains.
Assign a GLDv3-compliant network adapter to the virtual switch if each logical domain must communicate outside the box through the virtual switch.
- In Oracle Solaris 10, add a virtual switch service on network adapter driver to the control domain.
```
primary# ldm add-vsw net-dev=net-driver vsw-service primary
```
  For example, the following command adds a virtual switch service (primary-vsw0) on network adapter driver nxge0 to the control domain (primary):
```
primary# ldm add-vsw net-dev=nxge0 primary-vsw0 primary
```
- In Oracle Solaris 11, add a virtual switch service (primary-vsw0) on network adapter driver net0 to the control domain (primary):
```
primary# ldm add-vsw net-dev=net-driver vsw-service primary
```
  For example, the following command adds a virtual switch service (primary-vsw0) on network adapter driver net0 to the control domain (primary):
```
primary# ldm add-vsw net-dev=net0 primary-vsw0 primary
```
- The following applies to the Oracle Solaris 10 OS only and should not be performed on an Oracle Solaris 11 system.
  
  This command automatically allocates a MAC address to the virtual switch. You can specify your own MAC address as an option to the ldm add-vsw command. However, in that case, it is your responsibility to ensure that the MAC address specified does not conflict with an already existing MAC address.
  
  If the virtual switch being added replaces the underlying physical adapter as the primary network interface, it must be assigned the MAC address of the physical adapter, so that the Dynamic Host Configuration Protocol (DHCP) server assigns the domain the same IP address. See Enabling Networking Between the Control/Service Domain and Other Domains.
```
primary# ldm add-vsw mac-addr=2:04:4f:fb:9f:0d net-dev=nxge0 primary-vsw0 primary
```

Verify the services have been created by using the list-services subcommand.

Your output should look similar to the following:

primary# ldm list-services primary
VDS
    NAME             VOLUME         OPTIONS          DEVICE
    primary-vds0
 
VCC
    NAME             PORT-RANGE
    primary-vcc0     5000-5100
 
VSW
    NAME             MAC               NET-DEV   DEVICE     MODE
    primary-vsw0     02:04:4f:fb:9f:0d nxge0     switch@0   prog,promisc

Skip Navigation Links
Exit Print View
	Oracle VM Server for SPARC 2.2 Administration Guide Oracle VM Server for SPARC