Use one of the following command syntaxes depending on the operation you want to perform:
cfgadm -c configure controller – configures a SATA controller.
cfgadm -c unconfigure controller – unconfigures a SATA controller.
In both commands, controller refers to the SATA HBA Ap_Id, such as sata0/0. For more information about the Ap_Id, see About Attachment Point Identification.
The following example configures c7t0d0.
# cfgadm -c configure c7t0d0
The following example shows the state of c7t0d0 after it has been configured.
# cfgadm | grep sata0/0 sata0/0 disk connected unconfigured ok