JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Blade X4-2B Service Manual
Oracle Technology Network
Library
PDF
Print View
Feedback
search filter icon
search icon

Document Information

Using This Documentation

Service Manual Overview

About the Sun Blade X4-2B

Troubleshooting the Server Module

Preparing for Service

Servicing Server Module Components

Servicing a Storage Drive (CRU)

Identifying Storage Drives

Identifying Storage Drive Indicators and Mechanical Components

Ready to Remove Indicator

Service Action Required Indicator

Power/OK Indicator

Lever and Lever Release Button

Storage Drive Failure and RAID

About Disk Backplane Cabling

Remove a Storage Drive

Install a New Storage Drive

Replace a Storage Drive

Remove Storage Drive Filler Panels

Insert Storage Drive Filler Panels

Servicing DIMMs (CRU)

DIMM Fault Remind Circuit and ECC Errors

Fault Remind Button and Charge Status Indicator

DIMM Fault Indicators

Inconsistencies Between DIMM Fault LEDs and the BIOS Isolation of Faulty DIMMs

Error Correction and Parity

Identify Faulty DIMMs

DIMM Population Rules and Guidelines

Basic Memory Guidelines

Detailed Memory Population Rules

Remove DIMMs

Install DIMMs

Servicing USB Flash Sticks (CRU)

Remove USB Flash Sticks

Install USB Flash Sticks

Servicing a Fabric Expansion Module (CRU)

Remove a FEM

Install a FEM

Servicing a RAID Expansion Module (CRU)

Remove a REM Card

Install a REM Card

Replace a REM Battery on the REM Card

Servicing Processors (FRU)

Selecting the Correct Processor Removal/Replacement Tool

Processor Fault Remind Circuit

Fault Remind Button and Charge Status Indicator

Processor Fault Indicators

Identify a Faulty Processor

Remove a Processor Heat Sink (FRU)

Remove a Processor (FRU)

Install a Processor (FRU)

Install a Processor Heat Sink (FRU)

Servicing the Motherboard Assembly (FRU)

Remove Motherboard Assembly Components (FRU)

Install Motherboard Assembly Components (FRU)

Update FRUID (Service Only)

Servicing the System Battery (CRU)

Returning the Server Module to Operation

BIOS Power-On Self-Test (POST) Checkpoints

BIOS Setup Utility Menu Options

Index

Install a New Storage Drive

  1. Locate the storage drive filler panel in the server module bays.

    For drive locations on the server, see Identifying Storage Drives.

  2. Remove the storage drive filler panel from the server module bays.

    For instructions to remove drive filler panels, see Remove Storage Drive Filler Panels.

  3. Ensure that the storage drive release lever on the drive is in a fully opened position.
  4. Slide the storage drive into the vacant slot by pressing the middle of the storage drive faceplate with your thumb or finger until the release lever engages with the chassis.

    The release lever starts to close as it makes contact with the chassis. Do not slide the storage drive in all the way. Leave the storage drive out approximately 0.25 to 0.50 inch (6 to 12 mm) from the opening.

  5. Close the release lever until the storage drive clicks into place and is flush with the front of the server.
    image:Illustration showing the installation of the HDD in to the server module front.

    A pawl near the hinge on the lever engages the sidewall drawing the drive inward and seating the drive connector with the internal hard drive backplane connector.