Clear the LLDP Remote Table

LLDP remote table is updated whenever LLDP operates in the transmit and receive-receive only modes.

1. At both switches, configure the LLDP module status as enabled.

   See Configure the LLDP Module Status.

2. On both switches, enter the Global Configuration mode.

   SEFOS# configure terminal

3. Allow both switches to learn the neighbors, then clear the LLDP remote table.

   SEFOS(config)# clear lldp table
   SEFOS(config)# end

4. On both switches, review the remote table.

   SEFOS# show lldp neighbors
   Capability Codes        :
   (R) Router, (B) Bridge, (T) Telephone, (C) DOCSIS Cable Device,
   (W) WLAN Access Point, (P) Repeater, (S) Station, (O) Other
    
   Chassis ID        Local Intf        Hold-time    Capability    Port Id
   ----------        ----------        ---------    ----------    -------
   Total Entries Displayed    : 0