Configure the PMBR Status

Document Information

Using This Documentation

Product Notes

Related Documentation

Acronyms and Abbreviations

CLI Command Modes

Feedback

Support and Accessibility

Configuring the Topology Example

Enable IPv6 Support and Assign IPv6 Addresses

Configure PIMv6 in Router A

Configure PIMv6 in Router B

Global Configurations

Enable PIMv6

Configure the Group and Source Thresholds

Configure the SPT Switching Period

Configure the Rendezvous Point Threshold

Configure the RP Switch Period

Configure the regstop Rate Limit

Configure the PMBR Status

Configuring PIMv6 on an Interface

Associate the PIMv6 Component to an Interface

Configure the Query-Interval Value

Configure the DR Priority Value

Configure the Override Interval

Configure the LAN Delay

Configure the LAN Prune Delay

Configure the BSR Candidate

Configure the Message Interval

Configuring the PIMv6 Component

Create a PIMv6 Component

Set the Mode for the PIMv6 Component

Configure the RP-Candidate Hold Time

Configure the RP-Candidate Address

Configure the RP Static Address

Create an RP-Set Table

Create a PIMv6 Neighbor

Create Multicast Routes

A PMBR connects a PIMv6 domain to other multicast-routing domains. Configuring the PMBR status enables or disables the PMBR.

Enable PIMv6.

SEFOS# configure terminal
SEFOS(config)# set ipv6 pim enable

Enable the PMBR status.
```
SEFOS(config)# set ip pim pmbr enable
```

In VLAN 7, associate the interface with PIMv6 component 1.

SEFOS(config)# interface vlan 7
SEFOS(config-if)# ipv6 pim componentId 1
SEFOS(config-if)# end

Review the PMBR status.

SEFOS# show ipv6 pim interface detail
 
...
    PIM Component Id : 1
    PIM domain border : enabled
...

Review the interface details.

SEFOS# show ipv6 pim interface detail
 
...
    PIM Component Id : 1
    PIM domain border : disabled
...

Skip Navigation Links
Exit Print View
	Sun Ethernet Fabric Operating System PIMv6 Administration Guide

PIMv6 Administration Guide

Configure the PMBR Status