Configure an iSCSI SAN

  1. Verify that the Microsoft iSCSI Initiator and TCP/IP networking are installed and configured on the host.
  2. If you are using an iSCSI-to-FC router, configure the router as described in Configure the iSCSI-to-FC Router and enable the FC SAN communication between the FC ports on the router and the FC ports on the Oracle FS System Controller or Pillar Axiom Slammer.
  3. Set up the TCP network between the host and the iSCSI ports on the Oracle FS System Controller or Pillar Axiom Slammer or the iSCSI-to-FC router.
  4. After completing the above steps, configure iSCSI connections as described in this manual.

Copyright © 2006, 2014, Oracle and/or its affiliates. All rights reserved. Legal Notices