- From the Setup menu, select Add Target, then select Configure Auto Discovery.
-
In the Configure Auto Discovery section, in the Network Scan-based Auto Discovery table, in the Configure Network Scan Discovery column, click the Configure icon.
-
Click Create.
-
In the Network Scans section, click Add. Select a Management Agent that can scan the network.
-
Enter the IP ranges to scan.
The range can contain absolute host names, IP addresses, a range of addresses, or/and Classless Inter-Domain Routing (CIDR) notations.
-
In the Schedule section, schedule the scan job to run immediately or on/at a particular date/time.
-
In the Credentials section, enter the credentials of the Management Agent that you have selected for scanning the network.
-
Click Save and Submit IP Scan.
|
- From the Setup menu, select Add Target, then select Auto Discovery Results.
-
Click the Host Targets tab.
-
In the table, select a host, then click Promote.
The Add Host Targets wizard appears. Use this wizard to install a Management Agent on the discovered host.
-
Repeat Step (3) for other hosts you want to monitor.
|
- From the Setup menu, select Add Target, then select Configure Auto Discovery.
-
In the Configure Auto Discovery section, in the Auto Discovery table, against the All Discovery Modules row, in the Configure Auto Discovery column, click the Configure icon.
-
In the table, select the host whose targets you want to discover, and click Configure.
-
Set the frequency for the scan.
-
Select the discovery modules you want to discover on the host.
-
Click OK.
-
Repeat Step (3) to Step (6) for other hosts.
-
Click Run Discovery Now.
The discovery job runs on the host immediately as well as at the set frequency.
|